Planned Services

Planned Services

Keeps you comfortable because We Care!

Routine Service:

  • Maintains high efficiency
  • Lengthens equipment life
  • Avoids costly breakdown

Residential/Commercial:

  • Heating
  • Air Conditioning
  • Air Filtration – Humidification

PS Service Agreement Entitles You to the Following Services:

  • We schedule planned maintenance calls.
  • Priority emergency service.
  • 10% discount off preventative maintenance.
  • For 24 hour emergency, call 605-336-0545.
  • We service all makes and models of equipment.
  • Agreement can be canceled at any time by either party.

  • Clean condenser coil.
  • Test electrical connections for tightness.
  • Adjust system for optimum cooling.
  • Check for oil and refrigerant leaks.
  • Test safety devices.
  • Check blower belt wear, tension and alignment. (if applicable)
  • Test expansion valve and coil temperatures.
  • Clean or replace air filter.
  • Test refrigerant level.
  • Check condensate drain.
  • Lubricate as needed.

  • Clean and adjust automatic controls.
  • Clean burners.
  • Adjust combustion for optimum fuel efficiency.
  • Test for combustion leaks.
  • Test safety shutoff devices.
  • Check blower belt wear, tension and alignment. (if applicable)
  • Clean or replace air filter.
  • Replace humidifier media at fall inspection.
  • Check flue for satisfactory operation.

  • Clean and test automatic controls.
  • Check all wiring for loose connections and condition of insulation.
  • Check supply voltage.
  • Check amperage draw.
  • Lubricate as needed.
  • Check blower belt wear, tension, and alignment. (if applicable)
  • Clean or replace air filter.
  • Replace humidifier media at fall inspection.


  • Lubricate as needed.
  • Test defrost cycle and reversing valve operation.
  • Adjust air volume for maximum efficiency.
  • Test safety devices and electrical connections for tightness.
  • Check blower belt wear, tension and alignment. (if applicable)
  • Check for oil and refrigerant leaks.
  • Test electrical controls for proper operation.
  • Check refrigerant level.
  • Check refrigerant controls and coil temperature for maximum efficiency.
  • Clean or replace air filter.
  • Check condensate drain.

  • Combine Plan “A” with any other plan, “B” through “D”.
  • Two seasonal inspections, and cleanings per year, to insure year round comfort and reliability.

  • Install gauges and check operating pressures.
  • Check voltage and amperage to all motors with meter.
  • Check for adequate refrigerant charge and possible leaks.
  • Check evaporator coil.
  • Lubricate all moving parts.
  • Check belt and adjust tension.
  • Check filters.
  • Check pressure switch cut-out settings.
  • Check start capacitor and potential relay. (if applicable)
  • Check compressor contactor.
  • Check all wiring and connections.
  • Check and adjust thermostat.
  • Clean condensing coil.
  • Check that condensate drain is open.

  • Check and adjust thermostat.
  • Clean and adjust all safety controls.
  • Clean burners and controls.
  • Clean and adjust pilot assembly.
    • Check standing pilot
    • Check electronic ignition controls
  • Adjust burner for efficiency.
  • Check for gas leaks in furnace.
  • Lubricate moving parts.
  • Check belt and adjust tension.
  • Check filters and change if necessary.
  • Check vent pipe and draft diverter.
  • Test fan control.
  • Test manifold pressure.
  • Test furnace for cracked heat exchanger.
  • Test temperature rise.
  • Test complete furnace cycle.

With thousands of member and guest visits every day, we rely heavily on Baete-Forseth HVAC to keep our heating and cooling systems in top condition. Our pool areas need to be much warmer than our exercise areas. Even with the many challenges this type of facility provides, your entire staff does a wonderful job of handling issues in a timely manner.

TODD JORDRE • EXECUTIVE DIRECTOR, AVERA MCKENNAN FITNESS CENTER